• AFFORDABLE.
  
  
• EASY TO USE.
  
  
• ACHIEVES CONSISTENT PRE-LOADING OF IMPLANT ABUTMENTS AND SCREWS.
  
  
• EASY MAINTENANCE - STAINLESS STEEL - STERILIZE BY AUTOCLAVE OR CHEMCLAVE.
  

Tightening with the correct torque minimizes the risk of the screw working loose and improves the precision during bridge fabrication. Torque control can also reduce the risk of stress being built into the restoration and prevent component fractures.

The DynaTorq^® Wrench is a pre-calibrated torque wrench system that prevents over and under tightening of implant screws and abutments. It is available in 10Ncm, 20Ncm, 30Ncm, 32Ncm and 35Ncm settings to meet the needs of a variety of implant systems. An assortment of DynaTorq^® Drivers fit all the hex or slot head screws regardless of implant type.

Insert the screw or abutment into the implant with the DynaTorq^® Driver and tighten with finger pressure. Remove the DynaTorq^® Driver and place into the DynaTorq^® Wrench. Pre-load the screw by using the wrench in the same way as a ratchet wrench. The wrench clutch will disengage when the pre-calibrated torque is applied.

	Drivers fit all hex or slot head screws regardless of implant type		Shaft releases from head discontinuing torque drive at optimal pre-load
	See Full Chart		See Full Chart